I need helping finding the clutch switch wire(s)?

I'm currently installing the anti-lag (pre-spool) function on the apexi PFC and on the datalogit instructions it says to 1) Cut clutch switch wires. 2) Connect one wire through an additional (arming) switch from the standard clutch switch to terminal “SW3” on the FC-Box. 3) Ground the other clutch switch wire.

Kinda makes me think there's two of em. haha
So I need help finding the suckers. Any ideas would be greatly appreciated

 

It's at your clutch pedal. Can't remember the wire colors but they're a heavier
gauge than most.

There's a little white plunger that rests against your clutch pedal arm that closes
the circuit, so the car won't start.

 

I think you're talking about the other switch that's down there (clutch interlock). I do believe I found the right one because this one you can pull out and the car still starts.

 

Clutch switch lives at the "top" of the pedal, under the dash. The switch body itself can control the height of the pedal when it's up (adjusted to give little or no free play in the pedal). My wiring diagram has the wires as black and blue/orange stripe.

Starter interlock is on the firewall and gets closed whent he clutch is in. I recall this as two good sized black wires....