where can i get a a shorter belt for not having an airpump?

i have the greddy pulleys, i had to have the airpump and cat for emissions but now im done and i want the midpipe back on and the junk out, but i lost the belt.

 

Take a piece of string and run it around the path of the belt. mark where the ends meet and measure the distance. Then head down to NAPA or equal store and ask for that length belt. ( i;e: If the string measured 31 inches, you ask them for a 31 inch belt. Most belts are measured by the outer circumfrence distance) Hope this helps you out

FWIW: I think it is a 31 inch belt that is needed. But i have since switched the customer to all unortodox pulies. they are different still yet.

 

If you want to pay a little more, you can get a replacement Greddy belt:

http://rx7.com/store/rx7/fdengine_accessories.html

However, you can check this thread:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/air-pump-removal-belt-284790/

 

You can get it at strauss, you will need a 295K5.

 

The easiest way is to, like stated above, use a piece of string and outline the area with it...mark it, and get a belt of that size.

 

I ran a 295k4 b/c thats all I could find... no problems... I eventually removed the greddy pully kit due to low voltage output and put a 300k4 on stock pullies and it ran just fine... no slipping or anything.

 

thanks guys. i was wondering, what difference is there between the different pulley sets from different brands?