Ok I'm trying to get these clamps for my IC couplers and intakes because the one that i got in the local hardware store are kind of cuting them because of those cuts in them or whatever.

http://www.partssystems.com/shop/pro...egory_id=TBOLT

Now someone please tell me the sizes, cause i don't understand this fraction things.

I need them for the stock IC Piping, basically for stock Y-pipe, Ic to y-pipe, Ic to pipe that goes to UIM and Apexi intake.

the sizes on these clamps are in millimeters
59-82 mm
29-76 mm
65-89 mm

I know i need 10 of them all together.

thanks

 

I was also going to get the clamps from that company.. apprently they are the cheapest on the net..

I would measure your inner diamete with standard ruler.. that would be the best way..

If you could wait a week or so, I could tell you for sure..

 

You will need the 59-82 mm clamps. This is 2-3/8 to 3-1/4 inch range. The stock stuff is about 2-3/4 inches. Typical aftermarket couplers will require 3-inch clamps, so the 59-82 should work just fine.

 

cool, thanks