What size Clamps?
#1
Powered by** Rotary
Thread Starter
What size Clamps?
Ok I'm trying to get these clamps for my IC couplers and intakes because the one that i got in the local hardware store are kind of cuting them because of those cuts in them or whatever.
http://www.partssystems.com/shop/pro...egory_id=TBOLT
Now someone please tell me the sizes, cause i don't understand this fraction things.
I need them for the stock IC Piping, basically for stock Y-pipe, Ic to y-pipe, Ic to pipe that goes to UIM and Apexi intake.
the sizes on these clamps are in millimeters
59-82 mm
29-76 mm
65-89 mm
I know i need 10 of them all together.
thanks
http://www.partssystems.com/shop/pro...egory_id=TBOLT
Now someone please tell me the sizes, cause i don't understand this fraction things.
I need them for the stock IC Piping, basically for stock Y-pipe, Ic to y-pipe, Ic to pipe that goes to UIM and Apexi intake.
the sizes on these clamps are in millimeters
59-82 mm
29-76 mm
65-89 mm
I know i need 10 of them all together.
thanks
#3
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
You will need the 59-82 mm clamps. This is 2-3/8 to 3-1/4 inch range. The stock stuff is about 2-3/4 inches. Typical aftermarket couplers will require 3-inch clamps, so the 59-82 should work just fine.
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
rx8volks
Canadian Forum
0
09-16-15 09:07 PM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM