What gaskets are needed for a shortblock swap?
08-03-12, 11:50 AM
#1
Full Member
Thread Starter
iTrader: (5)
Join Date: Dec 2011
Location: Spring, Tx
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
What gaskets are needed for a shortblock swap?
I bought a brand new shortblock from mazda a couple months ago. It came completely built with oil pan, flywheel, waterpump, cover all preinstalled.
I am going single and installing a full aftermarket fuel system.
I have "like new" condition UIM and exhaust manifold gaskets, so I will reuse those. I need to order a LIM gasket for sure.
I am doing a full emissions delete on the car and plan to just silicon the block off plates.
Can anybody think of what gaskets I will be needing? OMP, etc?
I am going single and installing a full aftermarket fuel system.
I have "like new" condition UIM and exhaust manifold gaskets, so I will reuse those. I need to order a LIM gasket for sure.
I am doing a full emissions delete on the car and plan to just silicon the block off plates.
Can anybody think of what gaskets I will be needing? OMP, etc?
08-04-12, 09:46 AM
#4
Full Member
Thread Starter
iTrader: (5)
Join Date: Dec 2011
Location: Spring, Tx
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
yea, thats all i could find, but then i noticed 2 o-rings on the oil cooler - oil filter housing adapter and started wondering if i was missing anything else.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
