What does this ground go to?
Thread Starter
Senior Member
Joined: Sep 2003
Posts: 342
Likes: 1
From: Boise, Idaho
What does this ground go to?
After the engine swap I found a ground wire nut loose and it apears to have smoothed out it's idle a lot.
I'm just wondering what it goes to so I can better understand what was fouling my plugs.
It is the two ground wires off the 12mm bolt into the front or middle housing that holds the rats nest frame down, the temp sending wire also goes into the loom where they go.
the FSM is a PITA to understand.......
What do the grounds go to?
I'm just wondering what it goes to so I can better understand what was fouling my plugs.
It is the two ground wires off the 12mm bolt into the front or middle housing that holds the rats nest frame down, the temp sending wire also goes into the loom where they go.
the FSM is a PITA to understand.......
What do the grounds go to?
RX7 lover
Joined: Jun 2005
Posts: 1,160
Likes: 3
From: UK
There should be two grounds around that area, one attatches to the fuel rail feed assembly via a 12mm bolt (ontop of the rear rotor housing IIRC, under the coils) the other ground attatches to the coil assembly itself by an 8mm nut.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
Oct 3, 2015 01:08 AM
