What boost controller are you using with the PowerFC?
Thread Starter
Banned. I got OWNED!!!
Joined: Feb 2001
Posts: 102
Likes: 0
From: Silicon Valley Bay Area
In CA they add Oxygen to the fuel........ almost like carbonated drinks..... but with oxygen if u look at it in Layman's terms...... Do u really think adding O2 to the fuel helps the FD? Nope..... it needs more fuel......not O2...
Ghost Ride the Whip
Joined: Mar 2001
Posts: 1,467
Likes: 1
From: Foster City, CA
Seems like the only way to tune it is to run shitty 87 octane winter gas and then use 91 octane gas for daily driving........ this way it would be prepared for the worse.....
Well I do have the world's record for most miles on FD chassis and quite possibly the engines too........
Full Member
Joined: Oct 2002
Posts: 57
Likes: 0
From: Indonesia
I am using Blitz SBC. It holds the preset boost levels better and it reacts faster to any boost changes.I had the AVCR before, the turbos spool earlier and power is linear whereas the Blitz feels a bit brutal, but it does not hold as well or reacts as well to boost changes.This is my experience, other people may not feel the same about this.
Rotary Freak
Joined: Oct 2002
Posts: 1,625
Likes: 0
From: Salem, IN
i'm using the hallman es manual. i have it set at about 14 pounds with non-sequential. the pfc is like it came except i disabled the sequential mode and set all the boost settings to 1.1 bar to keep from fuel cutting. the knock level has not moved at all, not once.
Thread
Thread Starter
Forum
Replies
Last Post
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM
