What are ALL of the Home Depot mods...?
#38
Rotary Freak
Thread Starter
No pics yet. I have made a rough prototype with Sheet metal . That wraps over the re amemiya intake and then down toward the gap between the radiator and the frame, keeping the hot air from the radiator being sucked into the Intake.
I did buy a nice sheet of aluminum that i plan to make a cleaner looking & better fitting shield. I also plan to run some 3" hose/tubing up from the opening where the second oil cooler goes and literally zip-tie it to the front steel mesh of the reamemiya intake to create a cold-ram air intake. I wonder if the force of the air is going to damage the foam filter, oh well. I'll get some pics later...if it turns out good.
I did buy a nice sheet of aluminum that i plan to make a cleaner looking & better fitting shield. I also plan to run some 3" hose/tubing up from the opening where the second oil cooler goes and literally zip-tie it to the front steel mesh of the reamemiya intake to create a cold-ram air intake. I wonder if the force of the air is going to damage the foam filter, oh well. I'll get some pics later...if it turns out good.
Originally posted by 7-sins
I would like to see the cold air intake you made. I was thinking of doing something similar. Any Pics?
I would like to see the cold air intake you made. I was thinking of doing something similar. Any Pics?
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
06-03-24 03:25 PM