Okay, this is weird...check this out. I bought this set from a JDM front clip. On the USDM spec cars, on the parts catalogue, it shows there is one common hardline shared between the two coolers that doesn't have a connection in the middle..it shows it is a hardline from one cooler to the other, without interruptions..just a hard line. However, MY setup (from a JDM front clip) came where that common shared hardline is NOT connected...there is a flared connecting end on both ends of the two hardlines from each cooler as if there is a hose that should be connecting them. Can anyone verify that this is a genuine difference between the 2 hardlines?

I can just make my own line I guess...just curious

Trev

 

I have a JDM front clip as well

i'll have a look 2morrow..

at first glance they seemed the same to me tho

 

Not entirely sure what your trying to say, here's a late car

http://13b.power.ne.jp/main_contents...ge_img/042.gif

Going on memory, the install on a 92 rhd car over here was pretty much identical.

 

basically, I think that this specific set had been modified. No worries, I will make my own line.