I know there are several threads on this, I've looked through them and still can't figure it out. My twin power was disconnected and I'm trying to reconnect it. It's grounded and connected near the battery but the two other terminals are not connected to the leading and trailing coils apparently. If anyone can see what needs to be done I'd appreciate it. Trying to take my car to the track tomorrow and I'd like to have this up and running again. The car starts fine and the red light on the unit does not turn on when I start the car. Thanks.

 

try grounding in different areas. If that doesn't work, then it might be the unit itself??

 

No, I know it works fine. Ray at PFS unplugged it cause my dyno #'s didn't look right, ended up being plugs and wires. So I just think he left it unhooked. Then the leading coil was replaced. It's wired to the battery fine, I just need to know if the last pic is the 4 pin that it needs to be attached too. I can go take some better pics if need be.

 

Problem solved.

 

HOoray!

your twin power seems kinda far from the coil packs though?

 

Well, it said in the instructions to mount in a cool place. So I thought the coolest part would be near the battery. The wires reach is fine. Plus I didn't feel like making a bracket...I'm LAZY!!!