3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

turbo bearings

Thread Tools
 
Search this Thread
 
Old 03-06-06, 04:43 PM
  #1  
Obsessed

Thread Starter
 
zullo's Avatar
 
Join Date: Sep 2003
Location: Lenexa KS
Posts: 453
Likes: 0
Received 0 Likes on 0 Posts
turbo bearings

I am pulling everything out of my car again due to my sad story: https://www.rx7club.com/3rd-generation-specific-1993-2002-16/my-sad-story-511867/ in preparation for another engine.

My question involves the turbos. I have pulled them off and they are covered in burnt oil inside (exhaust side, clearly from engine). My concern is that there is also fresh oil dripping from the snails. Is this a sure sign the seals are gone on the bearings? Or is there some other possible explanation? I think I know the answer... I need some good news here...

No, it is not blow-by, as the turbos were clean when installed and only have 400 very conservative highway miles (no boosting or cornering) since then.

For what it's worth, turbos feel fine... spin freely, no excessive play..

Last edited by zullo; 03-06-06 at 04:46 PM.
Old 03-06-06, 05:39 PM
  #2  
Moderator

iTrader: (7)
 
dgeesaman's Avatar
 
Join Date: May 2002
Location: Fort Kickass
Posts: 12,302
Received 16 Likes on 15 Posts
Oil on the intake side is normal. They are blown when there is enough oil blowing by the seals to make visible smoke out the back when you're boosting. IME it's hard to tell that just from looking at the insides, unless it's to the point of puddles dribbling out of the intake pipes.

I would put them back on the new engine and only worry if you see a bunch more smoke after a few hundred miles.

Dave
Old 03-06-06, 07:45 PM
  #3  
Obsessed

Thread Starter
 
zullo's Avatar
 
Join Date: Sep 2003
Location: Lenexa KS
Posts: 453
Likes: 0
Received 0 Likes on 0 Posts
Thanks, Dave... that's encouraging. Probably 2 ml dribbled out of one side when I turned them over, and there was enough in the other side to coat my finger.

I will put them on and hope for the best...
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
tallbozo
1st Generation Specific (1979-1985)
3
08-15-15 02:47 PM
Engine stand ready
New Member RX-7 Technical
3
08-14-15 10:26 PM
WyomingTII
2nd Generation Specific (1986-1992)
5
08-13-15 10:42 AM



Quick Reply: turbo bearings



All times are GMT -5. The time now is 11:53 PM.