Turbo 2 DP question
#1
Senior Member
Thread Starter
Join Date: May 2004
Location: Browns Mills, NJ
Posts: 514
Likes: 0
Received 0 Likes
on
0 Posts
Turbo 2 DP question
I just put my car on a lift to check out the downpipe because I heard an exhaust leak, turn out two studs have broken off into whatever the downpipe connects to (turbo manifold)?
would I be able to drill the bolts out and replace them?
would it be costly?
anyone else have this problem before?
thanks-Nick
would I be able to drill the bolts out and replace them?
would it be costly?
anyone else have this problem before?
thanks-Nick
#3
Moderator
iTrader: (7)
If you take off the downpipe, will there be any stud left to grab onto?
If so, pull the dp, then I used a grinder to cut flats on each side of the bolt until it fit an open-end wrench perfectly. Combined with a bunch of PB blaster, they broke right out.
Unfortunately, I think if they break off flush the only real answer is to pull the turbos. There just isn't much room.
Dave
If so, pull the dp, then I used a grinder to cut flats on each side of the bolt until it fit an open-end wrench perfectly. Combined with a bunch of PB blaster, they broke right out.
Unfortunately, I think if they break off flush the only real answer is to pull the turbos. There just isn't much room.
Dave
Thread
Thread Starter
Forum
Replies
Last Post