Trouble Increasing boost
#1
Full Member
Thread Starter
Join Date: Mar 2003
Location: Silent Hill
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Trouble Increasing boost
Ok i am having trouble increasing boost. A few days back some vaccum was off and my car was running Non-Seq without doing the non-seq mod... i drove it for a few days boost use to come at around 4500 rpms but from there on it was a wild ride... i was hitting smooth .9 all the time... Now i have a fully functional sequential setup and when the secondary turbo kicks in boost drops to .7 only.... I tried increasing it from the boost controller. its a greddy E-01..and on the power fc nothing works... the primary turbo hits .9 but when the seconadary kicks in it drops to .7
Can it be that i have hooked up the boost controller wrong.... There were no instructions for installation on the rx-7 with the boost controller.. Which actuator do i need to connect the solonoid to..and which one do i have to cap off... Any pictures would help...
I have the following mods on my car..
Apex-i intakes
Apex-i N1 exhuast
Apex-i GT spec radiator
Apex-i Power FC
Knightsports Dual downpipe
Greddy large SMIC
Greddy E-01 Boost Controller
Street Ported Block
Thanks
Can it be that i have hooked up the boost controller wrong.... There were no instructions for installation on the rx-7 with the boost controller.. Which actuator do i need to connect the solonoid to..and which one do i have to cap off... Any pictures would help...
I have the following mods on my car..
Apex-i intakes
Apex-i N1 exhuast
Apex-i GT spec radiator
Apex-i Power FC
Knightsports Dual downpipe
Greddy large SMIC
Greddy E-01 Boost Controller
Street Ported Block
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM