Anyone ever have trouble with Greddy pulley kit? The hole in the Alt. pulley seems to be too small. It will not seat in the unthreaded part of the Alt. Anyone?

 

I have the GReddy pulley and didn't have any problems. Hmm...you might want to return that one and get another one.

 

yeah mine fit fine. i just pulled the old one off and slid the new ones on. its either a bad pully or a bad alternator stud

 

Fudge, I can't return it. I bought it from a guy on this forum. I asked him to help me send it back. Waiting on the answer.

 

sure its for an FD?

 

i sold many greddy elbow kit for fd, never has one that doesn't fit.

 

um yeah right we were talking about a greddy pully kit.

 

Have it honed to fit. Machine shop should only charge a few$$

 

fd3st04: Hes talking about the puylley not elbow. =']

Can you take some pics and post them??

 

Found out the problem. The guy that sold me the kit lied. He told me these were Greddy. They are not. They are knockoffs. Whoever made them had to be a ******* all they had to do was measure the diameter of the alt. shaft and they fucked that up. How hard is that?

allrotor93, I PM'ed you twice. You didn't respond to the first one where I asked you to help me return this so I sent you another PM asking for my money back. You gonna straighten this out or what? It's getting to a point where I can't buy **** off of this forum. This is the second time I'm gettin ripped off by a forum member. WTF??? What kind of satisfaction you get out of ripping someone for lousy 100 bucks.

allrotor93, paypal me my money back. I'm sending your fucked up pulleys. I think you sold them to me knowing that they are bad. And plus, you lied about what you were selling. Bottom line, THEY ARE NOT GREDDY!!

 

By the way, here's the ad.

https://www.rx7club.com/forum/showth...hreadid=132719

Note where he says he's selling "Greddy". Not some cheap *** knockoffs that don't fit. He probably made them himself.

 

Oh yeah, check out that pic with his engine. Notice he doesn't have the alt on there.

 

wow, calm down It is supposed to fit like that, slap some lube, and hammer it on with a rubber mallet. I installe dmine, it was teh same way an it came from Greddy. beat teh bastard on, it is better if it is tight.

 

I'll try it. But it's suppose to just slide right in like the stock.