hey fellow rx7club members,

my tranny bearings are going out so my warrenty will be taking care of the rebuild. i just bought the car and am new to the rotary scene. i was wondering if you guys with more exprience had any other suggestions of what to do since the tranny will be out? i was thinking about upgrading the clutch but havn't decided which one...kinda leaning toward the ACT street/strip w/ SRmotorsports 9.5lb flywheel. all input is welcome.

thanks
Germ

 

Retorque the rear engine bolts and replace the rear seal. Take the time to make sure the rear end pinion angle is correct, and check the rear end out for movement or leaking. Be sure to change the Pilot bearing before putting the tranny back on, new clutch or not....