Tightening the Mirrors?
#1
93 Touring
Thread Starter
Tightening the Mirrors?
Besides the two screws, is there any other point to tighten the outside mirrors?
Driver's side is fine, but passenger side, you can move the mirror base Even though both screws seem tight?
Thanks for any insight
ppritchard@cfl.rr.com
Driver's side is fine, but passenger side, you can move the mirror base Even though both screws seem tight?
Thanks for any insight
ppritchard@cfl.rr.com
#2
RX-7 Bad Ass
iTrader: (55)
You can pop the mirror inward to get to the two external screws. If those are tight, I THINK there are some more fasteners that you can get to from inside if you pull the door panel off. You may also want to remove the two externally accessible screws and see if you can pull off the mirror and if there's more underneath that.
Been a while since I messed with the mirrors but it should be something pretty easy in there.
Dale
Been a while since I messed with the mirrors but it should be something pretty easy in there.
Dale
#4
93 Touring
Thread Starter
Already changed motor mounts. It's a situation, sitting still where you can "turn" the base of the passenger mirror. Not sure if something "other than" the 2 screws hold this in check.
I've read that replacing the screws with "bolts" makes for a better lock -- not sure if that has anything to do with this though.
Thanks
I've read that replacing the screws with "bolts" makes for a better lock -- not sure if that has anything to do with this though.
Thanks