throwout bearing vs. clutch fork
#2
RX-7 Bad Ass
iTrader: (55)
Unbolt the fork from the tranny, both come right out.
Use grease on the collar around the tranny input shaft where the TO bearing rides, and a little grease on the "wings" of the TO bearing where it meets the fork. When re-installing the fork, use a little Loctite on the bolts.
Dale
Use grease on the collar around the tranny input shaft where the TO bearing rides, and a little grease on the "wings" of the TO bearing where it meets the fork. When re-installing the fork, use a little Loctite on the bolts.
Dale
Thread
Thread Starter
Forum
Replies
Last Post