throttle sensor always reads max??
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 14
Likes: 0
From: UK
throttle sensor always reads max??
on my AVCR the throttle position sensor is reading 100%. I checked the voltages via the "check sensors" menu and it is well over 4V. I checked the power FC and the voltage reading is the same so im guessing its nothing to do with the apexi units. Does anyone know what else i can check to sort out the issue. Im still running in the car after a rebuild but want it sorted before i get it mapped so the tuner wont have any problems
hope someone can help me
hope someone can help me
check the tps manually
use a volt meter and move the sensor from fully closed to fully open you should see voltage change gradually from .01v or roughly to a max of 5v if you do not then assume that the sensor is bad and needs to be replaced if its not that be sure to check the wiring for a short. either short to power or short to ground.
hope this helps.
Adam G
use a volt meter and move the sensor from fully closed to fully open you should see voltage change gradually from .01v or roughly to a max of 5v if you do not then assume that the sensor is bad and needs to be replaced if its not that be sure to check the wiring for a short. either short to power or short to ground.
hope this helps.
Adam G
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
Sep 5, 2015 10:23 AM
befarrer
Microtech
3
Aug 22, 2015 05:52 PM
