testing to see if car cranks... nothing. (just rebuilt)
#1
Full Member
Thread Starter
Join Date: Jun 2004
Location: IN
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
testing to see if car cranks... nothing. (just rebuilt)
Hey i just installed my power fc and hooked up my engine harness to see if the car would try to spin at all... and it didnt, which was almost planned because nothing ever goes right. I dont know what is going wrong though. the power fc commander isnt trying to come on at all... and when i press on the clutch to see if the car will crank, which the ebrake off... the parking brake light comes back on... is this something that occurs more than commonly? could the clutch pedal-brank light thing could be occuring because the 3 or 4 connectors down by the tranny are not connected? HELP!
thanks
thanks
#2
Wankel Shmankel
Join Date: Mar 2005
Location: Oahu (Hawaii)
Posts: 627
Likes: 0
Received 0 Likes
on
0 Posts
There's something wrong. The commander should come on even without the car cranking. In other words, when you turn the key, all the appliances (wrong word I know) along with the commander should come on. If the appliances come on and the commander doesn't, something wrong with commander. If nothing comes on, your car is probably not getting power (battery dead or not connected properly)
You should make sure all the connectors are connected and such.
You should make sure all the connectors are connected and such.
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM