How do i take out the harness that comes with the PFS PMS ecu from the stock ecu?? It's much more difficult since it's one big harness and not individual like the factory ones. Ideas anyone? I can't seem to pull them one by one since they are all connected!!! HELP!!! thanks!

Danny

 

You have to push in the connectors in on the bottom side in the middle. I t may kill your fingers but thats how it unglugs. Oh yea pull also ,very important

 

FD3SBOOST, i dont' fully understand, i should push in the individual connectors? and then pull on the yellow harness itself? I guess i dont' fully understand.

What i've been doing is pressing the regular tabs on each of the (4) connector tabs. But everytime i push one down and pull, i can't because the other 3 are holding the entire harness in. And then when i work to the other tabs, the tab i first released seems to pop back in. Only way i could think is to have some way of holding all 4 tabs down? there has to be something easier!

Danny

 

any other tips on this? it's soo annoying to have something so simple be soo difficult. ANd i've tried cursing at it..didn't work either...


danny

 

I saw garfinkle pull his -push atab at one end then pull that one out alittle then go to the next tab and press and pull then go to next one till all four are done .All this when on your side on the floor with a droplight in your way .It looks like to much run for me.so beat me ,make it hurt.