stuck seals?
#1
rx7spawn-R1
Thread Starter
Join Date: Apr 2004
Location: eudora, kansas
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
stuck seals?
my 93 has been sitting for a couple years and i am getting it going again. i am worried about the apex seals possibly being stuck. is there something to do before turning it over to help,just in case they are stuck.
#2
Mr. Links
iTrader: (1)
The easiest thing to do is to put some MMO down the intake runners and crank the engine by hand a few times. Other than that, if the seals are truely stuck, there are some other things to do but they will require you removing quite a bit of stuff.
Lubricate the system like above, change the oil, put some fresh spark plugs in, drain the gas tank and put in some fresh gas. After that, good luck!
Lubricate the system like above, change the oil, put some fresh spark plugs in, drain the gas tank and put in some fresh gas. After that, good luck!
#4
Rotary Enthusiast
after you do what listed above. run 4 oz's of mmo in with the fresh tank of gas and the next 3 or 4 tanks after that. this should clean and lube the fuel system and intake chambers.
Jeff
Jeff
#5
It's never fast enough...
Join Date: Feb 2001
Location: Miami - Given 1st place as the POOREST city in the US as per the federal government
Posts: 3,760
Likes: 0
Received 3 Likes
on
3 Posts
You may want to take a peak in your gas tank......
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/settlement-fuel-tank-732989/
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/settlement-fuel-tank-732989/
Thread
Thread Starter
Forum
Replies
Last Post
Snook
Single Turbo RX-7's
18
10-08-15 10:09 PM