Stock Quater Mile Times
The stock Mazda factory advertised time is 13.5 in the the quarter mile and 4.9, 0-60. I have all of the original FD magazine ads. I'd scan one of them with the #'s on it but they are framed on my wall. I have seen everything from low 13's to low 14's. Depends on the condition of the car (motor, turbos, suspension tires, etc.) If you can launch your car without getting excessive wheel spin or wheel hop, then you should have no problem hitting very low 13's with your mods. I have a stock 95 RX7 and cannot launch it correctly because the rear suspension is loose. The car runs fine, and with ONLY a straight through aftercat system it put down 238.2 hp and 226 ft lbs of torque which is well above stock numbers. If your car puts our similar numbers, expect mid to low 13's! Make your own Cold Air Induction and get a Down-pipe and Mid-pipe for mid 12's! Also, Drag radials will make a large difference.
-Kevin
-Kevin
Trending Topics
Originally posted by RavenRx7
so with an apex exhaust i'll looking at 13.8 ???
so with an apex exhaust i'll looking at 13.8 ???
It will depend on your altitude too. The track I run at is at 5800ft. and the fastest i've heard of and FD running is 13.9X. Over the summer I ran a 13.54 @ 105 with only a PFC and a DP. My launches were pretty crappy too. I think my car is capable of ~13.2-13.3 with the boost at 10PSI with a good launch.
(off the subject) your next mod should be a cold air induction system. Its almost pointless to have a catback exhaust besides the light weight, you need to let the car breath! Sorry I shouldnt say pointless, but you get the point.



and boost leak SOMEWHERE....

