smic install
#1
Full Member
Thread Starter
Join Date: Sep 2002
Location: indiana
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
smic install
I have looked on this forum and on the net and I can't find good instructions on installing a smic. I started myself but noticed there is a brace under the stock intercooler and I don't think I should take that out. Any help please. My car is in the garage for the winter and would like to get this done before it is too cold outside.
#2
Super Snuggles
It would probably help if you specified which SMIC you're dealing with.
Just FYI, they all install about the same. Remove the OEM IC, bolt the new one in (if equipped with mounting brackets), and then connect the piping (either new or OEM). If you have an ASP/M2 intercooler, then it rests on the cross brace under the stock intercooler and leans forward against the duct. Even if you don't, the cross brace more than likely stays in place.
Just FYI, they all install about the same. Remove the OEM IC, bolt the new one in (if equipped with mounting brackets), and then connect the piping (either new or OEM). If you have an ASP/M2 intercooler, then it rests on the cross brace under the stock intercooler and leans forward against the duct. Even if you don't, the cross brace more than likely stays in place.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM