Sesshoumaru

iTrader: (1)

I'm looking to buy some fuel injector clips for side feed injectors.

http://www.geocities.com/MotorCity/P...Injectors.html

list a few types of connectors.

The easiest is the bosch type top feed injector clips to get (like on FC).

I want new connectors when I install my flyin' lead kit on the haltech.

Know of any place that sells them?

DaleClark

iTrader: (55)

I've yet to find a source for the oval-shaped stock injector plugs on the FD. I did find a Miata in a junkyard once and cut all the injector connectors off of it for spares - it's the same connector, and they were easy to get to .

I would much rather have brand-new shells and pins. I've searched all OVER for electronics connectors (one of the things I really dig) and I've yet to find those connectors raw and brand new.

BTW, Blitz sells new side feed injectors that do come with a new connector, but I don't think they sell the connectors separately. But, it's a good thing to know if you buy the injectors new to replace old ones.

Dale

Mahjik

iTrader: (1)

For stock connectors:
https://www.rx7club.com/3rd-generation-specific-1993-2002-16/injector-connector-buying-373674/

For upgraded:
http://www.kgparts.com/newfuel.htm

Sesshoumaru

iTrader: (1)

I use ebay for bosch (or top feed's).

That first link seems like they are only available via dealer? I didnt' see anything on the RC engineering website.

I did see the blitz connectors. HKS makes a E "type" but there is no picture so i dont' want to buy them with out making sure.

I'll look a bit longer.

Sesshoumaru

iTrader: (1)

http://www.splparts.com/Parts/Silvia...el/default.asp

Those correct clips? I think it's the "sard" conversion clips.

Does anyone know what E type it is?

Make it much easier when searching

DaleClark

iTrader: (55)

That link to SPL Parts - I'm 99% sure the injector connectors at the top will work. Might be worth ordering one to double-check, and if it's good ordering the rest.

Dale

Sesshoumaru

iTrader: (1)

Well the thing is.......

I have a sr20det wiring harness from when I did the swap......... it might be a KA25DE though and they do not fit. They look VERY close but the oval for the FD is a bit wider.

That's why i think it's the Sard conversion ones but not sure.

This is the only thing I have against side feeds.......

Sesshoumaru

iTrader: (1)

If i can just get picture of 2E connector there are tons of places to buy those at.

http://www.horsepowerfreaks.com/view...or_Clips~.html

they also list a "Greddy connector" -that's almost too descriptive for words.......

DaleClark

iTrader: (55)

I believe the Greddy plugs are the square type for old-school top feed injectors - seems like I've seen pics of them before.

Dale