Casper23

Ok, i can't get above 7psi of boost. I bought my FD about 2 wks ago and it was only making 7psi. Thought it would be an easy fix, HA! It had a pfs dp and catback as well as tie wrap job. Since i had to check all hoses etc. anyway i put in the pfs intake and intercooler and replaced all couplings hoses. Still only 7psi. Went to non seq yesterday, still only 7psi. I am about to do the manual boost controller (while i check for the pills anyway) now that i am non seq, do i do anything to the precontrol or just leave it as is? Thanks to everyone, can't wait for full boost!!

Kas_Rx

i know you have checked your hoses, but yesterday i was on low boost also. I tightened the IC piping and hoses and wham, my boost was back.

just an idea?

Casper23

i checked all that again tonight while installing a manual boost controller. I thought going non sequential would do it. UgH!!

nmo93

did you plug the two solenoids into the right one(the wastegate and turbo precontrol one's). maybe you got them switched? nick

Casper23

i am not sure what you mean? If you are referring to the 2 under the presure chamber, i didn't unplug either, i capped the vacuum lines thought during the non-seq. conversion. I am using the pre-control now but i am about to switch to the wastegate.

nmo93

yeah, that's what i meant. if you switch them(which some people do) then you will only see 7-8psi. try the wastegate and let me know how it works out. nick