For those with a greddy FMIC are there any clearing issues with scoot hood?

Pics?

Thanks in advance!

 

I don't think people have clearance issues with that hood even though it has a scoop right through the center. I've seen some local cars with frount mounts and that same hood.

 

thanks for the reply. anyone have the hood with the greddy FMIC?

 

i don't think the FMIC would be any problem, but a SMIC would be, had to do some cutting on mines which sucks

 

You're thinking the piping would get in the way arent you? My friend has a 3row (with the fat as hell piping) and even that stays far away from the center. That intake on the scoot hood comes nowhere near where the piping is. I doubt this will be a problem at all

 

I have both. The only clearance issue was the strut bar which I just cut a notch in the underhood piece to correct.

Underhood pic, minus strut bar:
https://www.rx7club.com/attachment.p...hmentid=102689

 

I have the Greddy 2 row with a vented hood that dips below the stock hood lines with no issues.

 

no problems

 

I had to switch out my Cusco Sway bay for a flatter one but other than that.. the hood fits ok.. the FMIC doenst get in the way..
and the hood stand i just let it rest close to the bumper instead of the cradle for it..