Rx7 Rebuild
#1
Full Member
Thread Starter
Join Date: Jul 2005
Location: NJ
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Rx7 Rebuild
Well it was time for a full engine rebuild on my 93 rx. so i decided to pull her apart and take a look inside. I decided to go with 3mm apex seals curtousey of atkins rotary. Full rebuild kit with some insain street porting thanks to my dad. On the outside i slapped a t4 single turbo on her with a custom down pipe that just came together today, enlarged fuel system purchased from rx7store. Also I have to install my Microtech ecu and run my new harness. On the trans side i put a 6 finger act disk along with a act pressure plate. Wonder how shes ganna launch now. Before this rebuild i slapped on a large greddy FMIC. Im lookin into the launch kit from rx7.com dont really know much about these kits if they really help at all. But theres not much more to really do to the car before its coming back out i cant wait. Senior year sure goes good when I roll up in this car..
Last edited by pyromasterpaintball; 03-26-06 at 10:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM