just got back from the rx-7store.net
i got the motor done by pineappleracing its a large streetport with stage 3 oil mods and water upgrades, with 3mm seal . i installed.
couple pictures of the install from rx7store.

i got primary and secondary fuelrails, dual walbros, 1000cc primary 1600cc secondarys. all ss to the fuel pumps in the tank with am fuel filter.
an aftermarket oilcooler fabed to fit with thermostat and 10- ss lines.
will go dual when i go back and have boost controller and meth injectotion installed with the tune after brake in... and dyno #s after

pictures tommorrow.

 

Hey, how many miles do you have on it now?

This is Jacob@rx7store by the way.

 

998.00

 

old factory tps started giving me probs so i ordered all haltechs tps coolant and air sensors and connectors and will install before i return.

 

first ones of the oil cooler they fab to fit with ss lines and thermostat.
then fuel filter with ss all the way to the gas tank.
also dual walbros.

then primary and secondary fuelrails 1000 primary 1600 secondary.

just need to get in there and ziptie some wires and rerun some of those fuellines going to the nos.

was in a hurry and told them just to get it running and i would pretty it up.
ordered some haltech sensors like tps coolant and air will finish it up when i remove the intake manifold again.

 

here is the best ones .

the money shots

 

looks good.....

brad

 

your the first person that i have seen that is running No2, but i haent been around to long.
what fuel kit is that?
and what ems are you running?

 

its the kit the rx-7store sells you can also get it at kgparts.com

the nos is'nt running yet just hooked up and will probley go with 75 shot just to spool the turbo.

i have a haltech E6K

 

looks good