I am using the simplified vacuum system on a 94' TT. What resistors do I need and where exactly do I put them? Thanks, Jim

 

Someone will probably try to flame me for this, but you really don't need resistors. It will not cause the CEL (check-engine light) to illuminate on an N3A1 (non-CA) ecu. I'm not sure on the (N3A3) CA ecu. It may store a code without throwing the CEL, but that is up in the air.

 

On the same note, the resistance values for the solenoids can be found in the FSM, which is available for download in the sticky at the top of this forum

 

Here is a solution:
https://www.rx7club.com/showthread.p...27#post5333027