Resistor values for simplified wiring ?
#1
Junior Member
Thread Starter
Join Date: Feb 2006
Location: NY
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Resistor values for simplified wiring ?
I am using the simplified vacuum system on a 94' TT. What resistors do I need and where exactly do I put them? Thanks, Jim
#2
Rotary Enthusiast
Join Date: Feb 2005
Location: Charlotte, NC
Posts: 1,336
Likes: 0
Received 0 Likes
on
0 Posts
Someone will probably try to flame me for this, but you really don't need resistors. It will not cause the CEL (check-engine light) to illuminate on an N3A1 (non-CA) ecu. I'm not sure on the (N3A3) CA ecu. It may store a code without throwing the CEL, but that is up in the air.
Last edited by quicksilver_rx7; 02-21-06 at 10:31 PM.
#4
Rotary Enthusiast
Join Date: Dec 2001
Location: Sunnyvale, CA
Posts: 1,252
Likes: 0
Received 0 Likes
on
0 Posts
Here is a solution:
https://www.rx7club.com/showthread.p...27#post5333027
https://www.rx7club.com/showthread.p...27#post5333027
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM