replaces o rings on injectors and now car wont idle
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: Austin, TX
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
replaced o rings on injectors and now car wont idle
car will barely idle at 450-500 RPMs but if i hold the peddle down a little at around 800-850 rpmn i have good vac. and it sounds smooth. my PFC is set at 850 but the car doesnt respond to it. i even changed the PFC to 1300 rpm at idle and the rpms didnt do anything just stayed at 450-500. is there something that may be disconnected?
Last edited by KevinW; 06-20-05 at 01:04 PM.
#4
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: Austin, TX
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
where is that and why would it get messed up from just moving part of the UIM up to access the injectors? sorry for the wuestions but i jsut like to know how i mess things up so i dont do it again
#6
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: Austin, TX
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
well actually if i start removing vac lines the idle gets better so not sure if thats the case but i will still try and also i'll do a pressure test. could it be a clip or something that maybe came off or broke?
Trending Topics
#8
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: Austin, TX
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
i replaced the rings that go around the injectors, the ones that sit down inside the motor i left in place. but why wont the PFC control the idle at all, i mean if i adjust the fower fc idle to like 1500 RPM shouldnt it go up at least a little?
#10
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2004
Location: Austin, TX
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts
i didnt take anything off of the UIM i just rotated it up and left everything where it was, but guess it could have come undone from stretching. i'll check that but if it's not is there anything else. i'm asking because i dont have a computer at home so i need as much info as possible so i can check everything. i wont be able to check back here until tom. when i get to work
#12
I won't let go
Originally Posted by chillin_rx7_guy
sounds like TPS even though you didn't touch it or else....
If you have the ISC still in, the bleed screw won't do all that much (unless it's not working). You have to purposely turn that. I've never seen one anywhere that was inadvertantly (sp) turned.
Mine started to do the same thing, so I just pulled it out.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
ncds_fc
New Member RX-7 Technical
1
08-15-15 10:06 AM