hey guys, this winter i will be dropping my motor, going single and painting my fd chaste white i want the engine bay to be spotless. none of that messy wiring/vaccuum lines everywhere. i want to remove the ABS completely but i dont know how much a project this is. i want to put a sheetmetal box where the abs box/heatshield is where i can put my fuse box and as much electrical as posible. much like this build where his swirlpot is.

https://www.rx7club.com/single-turbo-rx-7s-23/gt35r-fd-build-%40-jeroentje-nl-631485/page2/

second post from the bottom.

thanks

 

removing the abs system isn't that hard....either you can retain the stock proportioning valve or get some aftermarket ones from like summit or something so you can re-route the brake lines, it's up to you.

rewiring the cars is more just like "wiring extensions"

all i can tell you is to be creative as to where you want to relocate the fuse boxes and whatever else, there are plenty of hiding spots in the FD

 

Hey let me know if you want to sell the abs pump. I am looking for one with low mileage and leak free.

Jeff

 

i will let you know when the time comes. how much are you willing to pay for it?

 

depends on the condition!. the last one I got leaked as much as my old one. so this time I want a good one. must be low mileage, leak and rust free. contact me when your ready.

Jeff