back on new years eve.. i blew my rear rotor.. (has compression on 1 face)


since then i've been scrounging up the dollars where and when i can while still trying to work on my FC...

i live in the middle of no where.. and shipping a reman is gonna be a fortune.. so i intend on rebuilding my REW...

i have 2 REW cores and an RE core to pick and choose parts from..

i've done a grocery list of parts.. in my possession i alerady have a set of 3 piece seals(that i don't intend on using) and a set of side seals

here's the list i put together... if u think there's stuff i can omit i'd appreciate it..

Part Name Part Number
Apex seals 2mm 2 piece 11-C00C-N351
Apex seals springs Lrg 11-C06C-N326
Apex seals springs Sml 11-C04A-N326
Side Seals 11-C110-N3Y1
Side Seals springs 11-C170-NF01
Corner Seal 11-C20A-N326
Corner Seal Springs 11-C240-NF01
Oil Control Rings 11-S10A-N3Z1
Oil Control Ring "O"Rings Lrg 11-3430-1202
Oil Control Ring "O"Rings Sml 11-3410-0820
Oil Control Ring Springs Front inner 11-3510-N225
Oil Control Ring Springs Front outer 11-353A-1011
Oil Control Ring Springs Rear inner 11-3610-N225
Oil Control Ring Springs Rear outter 11-363A-1011
Complete Engine Gasket Set 10-2710-8DFE
Rotor Bearings 11-B110-N3A1
Stationary Bearings 10-E260-NF01
Front Main Seal 10-5070-N3A1
Rear Main Seal 10-556A-1668
Rotor housing (Front) 10-S700-N3Y2
Rotor housing (Rear) 10-S800-N3Y2




it seems the only real expensive things are the Apex Seals, Oil Control rings, engine gasket set, and the Rotor housings(obviously)


any tips or advice?

TIA

 

Looks like you got a good list there. May look into getting new Thrust bearings and oil pump chain to be on the safe side.

 

I have a 1980 RX7 that runs rough at mid range. It starts fine but seems to miss a little at idle. It accelorates fine but at mid-range it cuts in-and-out. I've replaced plugs, wires, rotor, fuel filter. Nothings helped.

 

and what does that have to do with my thread?