Rear Brake Pad Replacement
#1
Senior Member
Thread Starter
Rear Brake Pad Replacement
I have the calipers off the car since I was painting them and installing new rotors, brake lines, speedbleeders, and pads. I'm using Hawk HPS pads and it looks like the V-Spring would sit in the groove between the 2 sections of pad surface, but in this pic:
It looks like the V-Spring is supposed to be installed on the bottom part of the pad, but with the HPS pads I don't see where that would go. Does anyone know for sure? TIA.
It looks like the V-Spring is supposed to be installed on the bottom part of the pad, but with the HPS pads I don't see where that would go. Does anyone know for sure? TIA.
#2
Full Member
Join Date: Feb 2001
Location: Bethpage, NY, USA
Posts: 175
Likes: 0
Received 0 Likes
on
0 Posts
whats up JR,
i had the calipers and all off a couple weeks go. I put on some braided stainless steal brake lines. The clip should go on the same way it was with the stock pads. I cant recall how it was off the top of my head but i will give you a call...
what kinda rotors did you get?
kenny
i had the calipers and all off a couple weeks go. I put on some braided stainless steal brake lines. The clip should go on the same way it was with the stock pads. I cant recall how it was off the top of my head but i will give you a call...
what kinda rotors did you get?
kenny
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM