Please see this thread. I accidently posted as a responce instead of a new thread.
https://www.rx7club.com/forum/showth...905#post878905

Thanks

 

the manifold is lookin perty farked....but the wheels dont look too bad...especially compared to mine from running over stock boost before i went m2....mine were all black and brittle..chipped from heat.

i wouldnt wanna put them on my car...but if they boost then someone may reallly be desperate for a set that works...if they are not leaking oil too.

is there any oil residue inside the snails?

honestly...Id probably only ask a little bit of money for them...but then again..I will never buy used turbos/ rebuilt turbos again.

j

 

Bryan,

Well I see you found the wastegate that you need to port. There's quite a bit of cracking I see. If you had no problems with boost before, then you might get away with those turbo's. Just as long as there is no play with the compressor wheel, then your thrust bearing/collar should be okay....but be sure to check both turbine's. A slight amount of up and down play is okay, but back and forth is bad. Check that first. I would go ahead and port the wastegates anyways, and run them on the car. Who knows, they may last you awhile until you can get some good BNR turbo's

 

haha...The next step is not upgraded twins, its single for me

 

Me too