Quick question, main pulley dimension needed

Reply Subscribe

Thread Tools

Search this Thread

07-21-13, 01:59 PM

wickedrx7

Rotary Enthusiast

Thread Starter

iTrader: (14)

Join Date: Apr 2001

Location: Chicago

Posts: 1,299

Likes: 1

Received 0 Likes on 0 Posts

Quick question, main pulley dimension needed

Can someone give me the OD of the main pulley? Approximate is fine, just need the of of the belt grooves as close as possible!

Thanks in advance!

Reply Like

07-21-13, 05:33 PM

fd3rew

Full Member

iTrader: (1)

Join Date: Jun 2005

Location: ny

Posts: 128

Likes: 0

Received 4 Likes on 3 Posts

old pic of crank pulley, if you need the od of the belt groove subtract a bit from the outer lip diameter. It may not look like it in the pic. but the measurement is taken across the center of the pulley.

Attached Thumbnails

Quick question, main pulley dimension needed-imgp1953a.jpg

Reply Like

Reply Subscribe

Related Topics

Thread

Thread Starter

Forum

Replies

Last Post

Installed UIM gasket, now my engine won't run

trickster

2nd Generation Specific (1986-1992)

07-01-23 04:40 PM

Atkins multirib pulley set, worth it?

LunchboxCritter

2nd Generation Specific (1986-1992)

01-03-16 04:11 PM

Wiring harness question

Professorpeanutrx7

New Member RX-7 Technical

08-15-15 01:38 PM

Reply Share

First
Prev
1 / 1
Next
Last