quick boost controller installation question
#1
quick boost controller installation question
i just installed the greddy profec b spec 2 boost controller, but im not sure if I caped off the right line.The line that i caped of are circled in the picture..i did many research but still not sure if my installation is correct and if those are wrong which ones are the right ones..thanks for your time.
#4
thanks YOUWISH...so that is version two setup..i thinks i know what im doing wrong now..im suppose to cap of the other nipple on the wastegate actuator going to the wastegate solenoid valve..but do i cap off the other nipple from the turbo compressor to the precontrol actuator as well..like what i did or do i leave that line connected.
#5
~~~~~~~~~~~~
iTrader: (5)
Join Date: Dec 2001
Location: San Jose, CA
Posts: 877
Likes: 0
Received 0 Likes
on
0 Posts
Dale Clark has an excellent write up for a B/C install.
http://www.clubrx.org/default.asp?AC...=68&id=5&mnu=5
http://www.clubrx.org/default.asp?AC...=68&id=5&mnu=5
Trending Topics
#8
if im not wrong these are version 2 of how to install the ebc. can someone get into details about installing version 1 ^^^^..(the way im installing it)..and would there be a difference in how it react from each version(which is better)...and in version 1 do i just leave the pre-spool actuator alone..or do i have to cap it off on both nipples too..thanks again.
#9
sleeper
iTrader: (6)
if im not wrong these are version 2 of how to install the ebc. can someone get into details about installing version 1 ^^^^..(the way im installing it)..and would there be a difference in how it react from each version(which is better)...and in version 1 do i just leave the pre-spool actuator alone..or do i have to cap it off on both nipples too..thanks again.
#10
Italian Rider
iTrader: (1)
Dale Clark has an excellent write up for a B/C install.
http://www.clubrx.org/default.asp?AC...=68&id=5&mnu=5
http://www.clubrx.org/default.asp?AC...=68&id=5&mnu=5
#11
Mr. Links
iTrader: (1)
#13
Mr. Links
iTrader: (1)
https://www.rx7club.com/3rd-gen-archives-73/my-boost-control-setup-perfect-10-8-10-pattern-242324/
#14
sleeper
iTrader: (6)
Check this for MBC install (although I would still recommend a EBC over a MBC):
https://www.rx7club.com/showthread.php?t=242324
https://www.rx7club.com/showthread.php?t=242324
Thread
Thread Starter
Forum
Replies
Last Post