quick ?
#1
Full Member
Thread Starter
Join Date: Dec 2006
Location: gainesville,GA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
quick ?
so i finally got a boost gauge....and noticed that in 3rd gear it hits 10psi then drops to a lil above 5 once it hits 10? didnt notice it in any other gear but i will check .....anything wrong with that? pretty sure there is..
thanks
thanks
#2
Weird Cat Man
What RPM does this drop occur at?
Is it in 3rd gear ONLY? What about 4th? 5th? (assuming you don't get pulled over going 100+ mph testing this out
Normal boost is going to hit 10 PSI then hold stead till around 4500 RPM
Then it will drop for a brief moment to around 7 PSI and then quickly recover back to 10 PSI and hold till redline.
This would be a "10-7-10" boost pattern. Sounds like you might have a "10-5-5" which might indicate that the pills are missing in your turbo control lines.
Do a search on "pills" and "boost" for more info.
The turbo control system is ridiculously complicated, but when it works right, it makes the car wonderful to drive!
Is it in 3rd gear ONLY? What about 4th? 5th? (assuming you don't get pulled over going 100+ mph testing this out
Normal boost is going to hit 10 PSI then hold stead till around 4500 RPM
Then it will drop for a brief moment to around 7 PSI and then quickly recover back to 10 PSI and hold till redline.
This would be a "10-7-10" boost pattern. Sounds like you might have a "10-5-5" which might indicate that the pills are missing in your turbo control lines.
Do a search on "pills" and "boost" for more info.
The turbo control system is ridiculously complicated, but when it works right, it makes the car wonderful to drive!
#3
Full Member
Thread Starter
Join Date: Dec 2006
Location: gainesville,GA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
hey thanks man...yeah i didnt take it to redline when i checked it out...was on a lil backroad...but i think when it dropped i was at around 4500 to 5500 but will check this out further tomorrow...thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM