Question about installing Profec B Spec II boost controller...
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Ontario
Posts: 726
Likes: 0
Received 0 Likes
on
0 Posts
Question about installing Profec B Spec II boost controller...
HI guys I did a lot of research and ended up installing it yesterday and it went pretty good. The car is still in storage so I couldnt tune it to see if everything is working right.
Anyway, after reading a write-up on clubRX, http://www.clubrx.org/default.asp?id...ntent=68&mnu=5 , I have a question. When I installed my spec II I only removed 2 lines but in the write up it says to remove 4.
In other words I only romoved the hose to the right in this pictures and not both (like shown in this pic)
Why is the one to the left capped?
I then connected the line from the turbo to the New boost controler valve and from the valve to the wastgate. The line coming out from the waste gate I removed and then capped like this (the 2nd and last line I removed for the install)...
So in short is the way I connected the boost controller Version 1 of the following pictures and the way it is done on the clubRX's how-to Version 2?
Sorry if this is a stupid question but I just wanted to be 100% sure.
Thanks, J
Anyway, after reading a write-up on clubRX, http://www.clubrx.org/default.asp?id...ntent=68&mnu=5 , I have a question. When I installed my spec II I only removed 2 lines but in the write up it says to remove 4.
In other words I only romoved the hose to the right in this pictures and not both (like shown in this pic)
Why is the one to the left capped?
I then connected the line from the turbo to the New boost controler valve and from the valve to the wastgate. The line coming out from the waste gate I removed and then capped like this (the 2nd and last line I removed for the install)...
So in short is the way I connected the boost controller Version 1 of the following pictures and the way it is done on the clubRX's how-to Version 2?
Sorry if this is a stupid question but I just wanted to be 100% sure.
Thanks, J
#2
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Ontario
Posts: 726
Likes: 0
Received 0 Likes
on
0 Posts
Hi guys, I just took a look at everything and am 100% sure what I am doing is Version 1 and what is shown on the clubrx write-up is Version 2 so you can just disregard my stupid question above. I should have just taken a closer look before posting this.
Sorry.
Sorry.
#4
Senior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Ontario
Posts: 726
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by rynberg
Did you cap the lines coming from the stock solenoids?
I then removed the line going out of the same waste gate (at the bottom) and capped it at the waste gate and at the line going to the waste gate control solenoid.
Sound right?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM