push start button help.
#1
push start button help.
HEllo,
I was wondering if I could get some help. I looked at wiring the push start button and have to wire it to the ignition switch now. The colours on the diagram do not correspond to the wires in my car.
I have 2 solid black wires and 2 blck and blue wires coming out of the ignition switch. Can someone clarify which wires I should be suing?
Thanks
I was wondering if I could get some help. I looked at wiring the push start button and have to wire it to the ignition switch now. The colours on the diagram do not correspond to the wires in my car.
I have 2 solid black wires and 2 blck and blue wires coming out of the ignition switch. Can someone clarify which wires I should be suing?
Thanks
#2
get a test light. ground it and stab the wires coming off the switch. you want the one that is hot only during cranking. cut that one. run the car side of that wire to the new switch. get a 12v source that is hot during run and piggy-back it to the other side of the new switch
Thread
Thread Starter
Forum
Replies
Last Post
Jose A.
3rd Generation Specific (1993-2002)
19
08-27-15 11:41 PM