pulley noises
#1
The Sleeve
Thread Starter
Join Date: Apr 2006
Location: merseyside
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
pulley noises
Hi all, i have a jap car and the pulleys make a dreadful noise now, the inner part of the second pulley in doesnt move, and its making a terrible racket until i put pressure on it. what have i done?
Is it costly repair?
Is it costly repair?
#5
Moderator
iTrader: (7)
Well since I'm not sure exactly which pulley you're referring to, I can't say which should be spinning when. The air pump and A/C compressor have clutches that only spin with the wheel part time. Others spin full time, but the center of the bearing of course does not rotate.
Pretty much any competent garage should be able to find the problem and fix it. You might be best off going that route.
Dave
Pretty much any competent garage should be able to find the problem and fix it. You might be best off going that route.
Dave
#6
The Sleeve
Thread Starter
Join Date: Apr 2006
Location: merseyside
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
pulley time!!
its the one on the left, here, the inner doesnt spin,
was wondering how to put a new one on, especially how do i loosen belt?
You are great all of you
was wondering how to put a new one on, especially how do i loosen belt?
You are great all of you
#7
Senior Member
Join Date: Feb 2006
Location: mooresville
Posts: 454
Likes: 0
Received 0 Likes
on
0 Posts
^that is the idler/tension pulley, loosen the nut on the pulley face the unscrew the jack bolt on the backside untill you can get the belt off then remove the face nut and the pulley will come off....the bearing is just a generic, ushually NOK or Natchi, any good bearing house should be able get one for less than $20 or you can get the whole pulley @ a parts store.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM