Propane Injection
Propane Injection
has anyone with an RX-7 attempted propane injection of any sort? The guys at 3si.org (3000GT/Stealth International) are having lots of luck
normal boost on pump gas with boost controller/intake/exhaust = 14.7psi, but with propane, a steady 20psi can be obtained
kits are around $300 too
normal boost on pump gas with boost controller/intake/exhaust = 14.7psi, but with propane, a steady 20psi can be obtained
kits are around $300 too
i know i'm not the most knowledgeable on the subject, but propane is a new one on me. i've heard of water injection of course, and alcohol injection... what are the advantages/differences of propane over these?
I had propane/NOS on my Viper. I got rid of it after I was rear ended in my 540i. It crushed the trunk to the back seat. And I thought "what if". When it ran it was great 300 shot on a stock fuel system with propane. It has done equally as well on supercharged Vipers but only with the NOS.
There were a few threads in the Rotary Performance section a few months back. Do a search there. From what I remember it raises the octane and helps cool the intake charge, allowing you to run more boost then the stock fuel system will allow.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM
eplusz
General Rotary Tech Support
15
Oct 7, 2015 04:04 PM





