problem with non sequential boost
#1
Junior Member
Thread Starter
Join Date: Jul 2008
Location: Montreal,Qc
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
problem with non sequential boost
so here is the thing, i have a 92 jdm FD running non-seq with hks feed tunned piggy back, just did a rebuild this summer. So right after the rebuild the boost is kept at 7 psi by blocking the vacuum hose coming from the waste gate actuator. i drove it for about 1000kms decide to crank up the boost to 0.8 bar (about 12psi). then i bought a manual boost controller from eBay connecting it to the blocked vacuum hose. tested it out, It's not boosting over 0.5 bar whatsoever,then i try to remove the manual boost controller let the vacuum hose fully open, the boost goes up quickly.
PS. first i thought its the problem with the boost controller so i called the vendor and they sent me a new one, result is still the same.
maybe i installed the boost controller wrong? does anyone have a picture of how manual boost controller should be installed on a non-seq?
PLZ HELP..
Here is a picture of how the boost control is connected
PS. first i thought its the problem with the boost controller so i called the vendor and they sent me a new one, result is still the same.
maybe i installed the boost controller wrong? does anyone have a picture of how manual boost controller should be installed on a non-seq?
PLZ HELP..
Here is a picture of how the boost control is connected
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
tiger18
3rd Generation Specific (1993-2002)
9
09-03-15 08:27 PM
3rd, boost, club, controller, fd, generation, install, manual, mazda, problem, problems, rx7, senquential, sequential