Primary injector rail problem...
#1
Aint no broke nigga
Thread Starter
Join Date: May 2003
Location: Seymour, TN
Posts: 776
Likes: 0
Received 0 Likes
on
0 Posts
Primary injector rail problem...
I was tighting one of the bolts on the primary injector rail and broke one of them. I drilled the bolt out and re-tapped it, but i drilled a little too much around the top and it isnt working. Is there any other way I can seal it on one side of the rail without causing a major vacuum leak? Thanks
#4
Rotary Enthusiast
iTrader: (14)
So you drilled to much out of the Center housing. You are still ok if you didn't drill to deep.
You have a few options some expensive some relitivly cheap.
1. you can coat the bolt in some grease and add some jb welt to the hole and install the bolt. it sounds dumb, but you will be amazed what that stuff holds up too.
2. you can enlarge the hole to add a lager standard or metric bolt.
3. Go get a heliacoil kit and intall it.
Good luck and try not to get frustrated.
You have a few options some expensive some relitivly cheap.
1. you can coat the bolt in some grease and add some jb welt to the hole and install the bolt. it sounds dumb, but you will be amazed what that stuff holds up too.
2. you can enlarge the hole to add a lager standard or metric bolt.
3. Go get a heliacoil kit and intall it.
Good luck and try not to get frustrated.
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM