Power Window issue FD JDM 1993
#1
Power Window issue FD JDM 1993
Hello, my windows stopped working both at the same time.
My car is a 1993 JDM rx7.
read JDM
read JDM
First, I tried to check the fuses with a USDM wiring diagram, but it's obvious the 30A fuse is nowhere to be found on my JDM car. Where the f is it? (not by the drivers foot, thats for the USDM version guys!)
The regulator does its job when directly wired to the battery (window goes up and down).
I did the fix/clean of the main switch, but result is windows still don't work.
Then I decided to check if there is power going through the wires of the switch connector (inside door, panel removed) with ignition switch at ON.
I get reading of 0.05V only.
Is there an expert who can help me by pointing out where and how to look for a diagnostic or a solution plz?
thanks
My car is a 1993 JDM rx7.
read JDM
read JDM
First, I tried to check the fuses with a USDM wiring diagram, but it's obvious the 30A fuse is nowhere to be found on my JDM car. Where the f is it? (not by the drivers foot, thats for the USDM version guys!)
The regulator does its job when directly wired to the battery (window goes up and down).
I did the fix/clean of the main switch, but result is windows still don't work.
Then I decided to check if there is power going through the wires of the switch connector (inside door, panel removed) with ignition switch at ON.
I get reading of 0.05V only.
Is there an expert who can help me by pointing out where and how to look for a diagnostic or a solution plz?
thanks
#2
Rotary Enthusiast
when my windows stopped working, it was the wiring harness that runs from the chassis into the door..not the switch.
Infact, it was some of the pins in the big connector there that had rusted away.
Infact, it was some of the pins in the big connector there that had rusted away.
#4
Rotary Enthusiast
Just try to jumper the power from before that connector to after it and see if it works