Porting WG
#1
TRINGLS
Thread Starter
Join Date: Apr 2004
Location: Clermont, FL
Posts: 1,053
Likes: 0
Received 0 Likes
on
0 Posts
Porting WG
I have my turbos seperated so I can port out the WG a little since it is out anyways but I'm worried about doing things wrong.
Can I just tape off the inlet/outlets of the turbos so that no shavings from my porting enters and possibly does damage? Also, how far do I port it?
I dont want to go beyond the flapper door size but how close to the edge of the door can I go? Also, is there a replacement flapper door that would be larger or better to use?
Thanks,
~Kris
Can I just tape off the inlet/outlets of the turbos so that no shavings from my porting enters and possibly does damage? Also, how far do I port it?
I dont want to go beyond the flapper door size but how close to the edge of the door can I go? Also, is there a replacement flapper door that would be larger or better to use?
Thanks,
~Kris
#2
From a previous write up I read with going non-seq; I believe it's on the scuderiaceriani.com/rx7 site on the poor man seq. link(not sure). I remember reading a 1.25 inch diameter expansion. So about .62" each radius? Other people please confirm or correct me!
Jeremy
Jeremy
Thread
Thread Starter
Forum
Replies
Last Post