is there an EASY way to change the plugs and wires? i can't even see the front two... is it better to get at it from under the car? (i can use full car lift at the post craft shop) or do i have to start removing the intake manifold, the IC pipes and whatever else is between the hood and the plugs?

 

http://www.rx7turboturbo.com/robrobi...plug_wires.htm

I always do the plugs from the bottom.

 

I go from underneath the car too so much easier make sure you put some axle stands under the car tho.
it took me about 45 minutes this way.



shaQ

 

thanks guys... i figured it would be easier from the bottom... can you run new wires from below also? or is that a take off the intake type of thing?

 

I found I had to take off the throttle elbow and throttle body to get access to pull off (cut off, in my case) the wires. The area around the top connectors of the wires is extremely confined.

If you have to do the wires, do it from the top. There are probably people who've changed wires from underneath, but I wouldn't trust myself to get them seated right.

 

actually I find it easier to change the rear plugs from the top and the front plugs from the bottem. But thats just me

 

Acutally that's what I did too - but either way we both removed the top stuff.

Dave

 

I did mine from the top. Isn't that hard..

 

I did my plugs and wires from the top. It sucked. Next plug change will be from the bottom.

 

I always do mine from the top. I tried the bottom but I didnt' like it, tops fine for me and I have big hands and forearms so i don't want to hear people saying "Oh, my hands are to big and they don't fit"