PFC/ID2000 Settings
#1
PFC/ID2000 Settings
I've been asking this in the PFC forum for weeks, no reply:
I recall when I upgraded to 1300 secondaries years ago, I went into the PFC commander and changed a couple settings to account for them, and that was it. Is this still possible with ID2000s? If so, what's the procedure/numbers?
Thanks
I recall when I upgraded to 1300 secondaries years ago, I went into the PFC commander and changed a couple settings to account for them, and that was it. Is this still possible with ID2000s? If so, what's the procedure/numbers?
Thanks
#2
Rotary Enthusiast
iTrader: (19)
Join Date: Apr 2002
Location: Colorado Springs, CO
Posts: 1,169
Likes: 0
Received 11 Likes
on
10 Posts
I think injector dynamics posts the lag times on their website. You need to input this in the settings 5 tab, you also need to change the secondary size in the settings 5 tab as well.
If you want to scale the entire base map, the injector % value you would use is 42.5% (secondary injectors).
If you want to scale the entire base map, the injector % value you would use is 42.5% (secondary injectors).
#3
As I'd noted in the PFC forum, I don't know what lag times are or what I would take from injector dynamics site and put where in the PFC or what scaling the entire map means.
I need "go to this screen on the commander, insert this value in this place" directions, IF this can indeed be done on the commander (I recall I did for 1300's), I don't have a dataloggit. If there's more to it than that, then I need to know that.
Thanks!
I need "go to this screen on the commander, insert this value in this place" directions, IF this can indeed be done on the commander (I recall I did for 1300's), I don't have a dataloggit. If there's more to it than that, then I need to know that.
Thanks!
#4
All out Track Freak!
iTrader: (263)
Join Date: Jul 2001
Location: Charlottesville VA 22901
Posts: 10,672
Received 412 Likes
on
250 Posts
As I'd noted in the PFC forum, I don't know what lag times are or what I would take from injector dynamics site and put where in the PFC or what scaling the entire map means.
I need "go to this screen on the commander, insert this value in this place" directions, IF this can indeed be done on the commander (I recall I did for 1300's), I don't have a dataloggit. If there's more to it than that, then I need to know that.
Thanks!
I need "go to this screen on the commander, insert this value in this place" directions, IF this can indeed be done on the commander (I recall I did for 1300's), I don't have a dataloggit. If there's more to it than that, then I need to know that.
Thanks!
I'd suggest getting a datalogit and going that route.
Last edited by Fritz Flynn; 06-22-15 at 11:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
rx8volks
Canadian Forum
0
08-13-15 04:55 AM