PFC/ID2000 Settings
 

I've been asking this in the PFC forum for weeks, no reply:

I recall when I upgraded to 1300 secondaries years ago, I went into the PFC commander and changed a couple settings to account for them, and that was it. Is this still possible with ID2000s? If so, what's the procedure/numbers?

Thanks

I think injector dynamics posts the lag times on their website. You need to input this in the settings 5 tab, you also need to change the secondary size in the settings 5 tab as well.

If you want to scale the entire base map, the injector % value you would use is 42.5% (secondary injectors).

As I'd noted in the PFC forum, I don't know what lag times are or what I would take from injector dynamics site and put where in the PFC or what scaling the entire map means.

I need "go to this screen on the commander, insert this value in this place" directions, IF this can indeed be done on the commander (I recall I did for 1300's), I don't have a dataloggit. If there's more to it than that, then I need to know that.

Thanks!

Pete he's is saying you would have to change the whole fuel map by hand and you don't want to do that. It's a major pia

I'd suggest getting a datalogit and going that route.

Yuo can't do it on the commander and yes the whole fuel map really needs to be redone. If you have access to a datalogit or want to send me your pfc i can give you a base map.