Passenger door lock "cover"
#1
Full Member
Thread Starter
Join Date: Oct 2008
Location: Denver
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Passenger door lock "cover"
So I was lubing my lock mechanisms on my passenger side door and I just finished lubing it from the backside behind the triangle piece and I decided to spray some lube into the cylinder as well, as I go to stick the key in afterwords to get it rubbed in good. The little white plastic door that covers the actual inlet broke in half...the top part came off and fell back in there...I just ran up here to see if I could find some easy schematics to remove the thing. I will try to get it removed and in a brighter area to see if I can fix it...(Garage has horrible lighting......i know, i know, I am working on that). Any ideas would be appreciated though.
obie
obie
#2
Full Member
Thread Starter
Join Date: Oct 2008
Location: Denver
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
mk I have it the two rods disconnected...is there an easy way to disconnect that green wire that runs into the door without removing the door panel and whatnot?
#5
Full Member
Thread Starter
Join Date: Oct 2008
Location: Denver
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
i got the spring still but the door broke in half...is there any way to get a replacement door or should I just pull that spring out and not worry about it anymore?
#6
haha this happened to my driver side first and now it just happened to the passenger side like a week ago...i just pulled out the pieces with some small pliers and it still works fine...just be carefull it doesn't get clogged up with anything...
#7
Senior Member
Join Date: Dec 2004
Location: The Netherlands
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
The latch behind the keyhole is weak because it's made of transparent plastic instead of metal as on must cars.
It's plastic because that will let through the light that goes on when you pull the doorhandle.
just make a new one from a piece of metal or maybe an old CD.
It's plastic because that will let through the light that goes on when you pull the doorhandle.
just make a new one from a piece of metal or maybe an old CD.